Difficulty locating chipset update file for Intel® 6, 5, 4, 3, 900 Series...
I ran the Intel Driver Update Utility and it recommends that I update the chipset driver. However the file was moved and I don't know which file to choose. Can someone tell me which driver to get? The...
View ArticleRe: Intel Gelelio Not Recognized When I use RS-232
Oh, I am so sorry. I've completely forgotten this post as I cannot find it under my profile. In reference to Diego's reply, I've managed to get the cable which was custom made. But it was not working,...
View ArticleRe: Cannot Acecss Galelio LINUX OS
When I got the custom made RS232, I asked the hardware person to make it for me since I don't have the necessary materials to cut it. And the cable colours are all different from whatever examples that...
View ArticleRe: WiFi Latency
I can't yet offer you a solution but what I can do is help validate what you are seeing. Below are some sample ping times for my edison on wifi (802.11n network). Other wireless devices in the house...
View ArticleWhy is connmand soaking up 25% of my galileo CPU?
connmand seems to be the 1st entry most of the time when I run "top":root@GalileoEnet:~# top Mem: 110224K used, 127844K free, 0K shrd, 6820K buff, 83480K cachedCPU: 40% usr 60% sys 0% nic 0%...
View ArticleRe: Suitable SD voltage level translators?
I had seen the limitation on pull up resistor value, and had intended to use 100k pull ups. Unfortunately, I missed the fact that DAT3/CD can have a smaller pull up on the SD card side. I like the...
View ArticleRe: Suitable SD voltage level translators?
Yes, the internal pullups should be fine. Just make sure that you tie the OE pin to VCC, so that the pullups are active as soon as the board gets power. If OE is low then you don't get any pullups.
View ArticleClik here to view.
Re: Do I need to replace the antenna?
No I haven't gotten it yet I plan on ordering it this week and then as soon a I install it I will let you know how it goes.
View ArticlePurpose of the 40 pin connector on top of the Edison
I note in some photos there's a 40 pin on top of the Edison (opposite face to the 70 pin DH40 underneath) What signals does this connector connect to?
View ArticleRe: Is it possible to call fastDigitalWrite from a C program running in Linux
Yes, thanks. I did exactly what you suggested when I wrote the program to benchmark pin 2/3 IO. My original question was about mixing and matching the headers and libraries under...
View ArticleRe: Intel AC7260 limited access after sleep
What version of Intel Smart Connect are you guys using and did you get it from Intel or Lenovo? I think I may have pinned down the source of the problem and it will be incredibly dumb on Intel and...
View ArticleGalileo CPU benchmarking results
First, let me caveat the results here-in; this benchmarking is pretty rudimentary and I've performed it just to get a rough comparison between the Galileo running Quark and the other microcontrollers I...
View ArticleIntel S5000XVN Memory issue - board hangs while scaling to 32 gi's of memory
I have the Intel S5000XVN motherboard and have gotten great use out of it for several years as my vmware server. I recently decided to double my memory on this board from 16 gigs of memory to 32 gigs...
View ArticleRe: 7260 AC Laptop card interfering with other 2.4Ghz Devices
Turning the Asus laptop with the 7260 AC card to 802.11g as well as turning off the 5Ghz radio on my router all 802.11b/g devices were able to connect. Unfortunately I'm no closer to determining the...
View ArticleRe: HD 4600 HDMI audio problem | Intel Communities. It disappears from...
II have already updated the Inter driver to the latest one but still the problem persists. I will try and update the BIOS. Also another member has suggested using a HDMI switch which I have ordered...
View ArticleIntel Galileo Maximum Interrupt Frequency
Hi all, I have been trying to use the Interrupt technique to count the rising and falling edge signal from the optical encoder. I did a test using a function generator (TTL square wave).I have found...
View ArticleClik here to view.
Re: D54250WYKH with 0028 BIOS, access to "Processor cores" settings
Hi Allan, Using 0027 it just run fine, I can change the memory speed multiplier and HD5000 graphic core multiplier too. While in the 0028 both of the option are disabled. And Intel SRT confirm worked...
View ArticleRe: POE - "With installation of PoE module"
Hi TeQ, Let us research this issue. We will post it over here when we have an update. Regards, JPMontero_Intel
View ArticleRe: Stuck on acceptance of site use terms
Hi Silenus, We suggest you to post your question in the IoT forum, here is the link https://software.intel.com/en-us/forums/internet-of-things. They should provide you a more accurate response. I hope...
View Article