Same problem here. I am using my NUC DN2820FYKH as PVR + Media Center in combination with a Philips flatscreen TV (it acts as the NUC's monitor). Every time I press "Power on/off" on the Philips IR remote, this will power up the NUC as well, regardless from the state it was in before. I have two Philips TVs with different IR remotes, but both can power up the NUC, so I think the Philips' on/off code is used by the NUC too.
I find this annoying because usually the last unit to be turned off is the TV (NUC's monitor!). And by doing that the NUC ist powered up again.
This might even ruin a preprogrammed timer recording, since the nuc doesn't go to sleep or is powered up accidentially by turning on the TV.
One simple solution would be to disable "wakeup by IR" in the NUC's BIOS but I didn't find anything there (Vers. 0038).
Is there any other solution or workaround?
Any plans to integrate the proposed function into a later BIOS?